Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Cequent
Performance Products, Inc.
Website: www.cequentgroup.com
Technical Assistance: 800-632-3290
TechnicalSupport@cequentgroup.com
To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE:
ALWAYS read, understand and follow warnings and instructions
for your hitch BEFORE installation. Keep for future reference.
DO NOT cut, weld or modify this receiver.
CHECK all fasteners are tight and your hitch is securely mounted
to your vehicle periodically.
ALWAYS read, understand and follow all warnings and
instructions for your vehicle and for other accessories you will use
with your hitch BEFORE use.
LOAD the trailer heavier in front.
DO NOT exceed lower of towing vehicle manufacturer's rating or:
Hitch Type
Max Gross Trailer
Weight Carrying
2000 lb. (908 kg)
Weight Distributing
ALWAYS wear your seatbelt.
SLOW DOWN when towing, NEVER exceed any posted speed limit.
If EXCESS SWAY occurs, take your foot off the gas pedal and hold
the steering wheel as steady as possible. DO NOT apply your
brakes and DO NOT speed up.
©2016, 2017 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 24941, 77328, CQT24941
Max Tongue
Weight
Weight
200 lb. (90.8 kg)
X
X
LIMITED LIFETIME WARRANTY
1.
Limited Lifetime Warranty ("Warranty"). Cequent Performance Products, Inc. ("We",
"Us" or "Our") warrants to the original consumer purchaser only ("You" or "Your") that the
product will be free from material defects in both material and workmanship, ordinary wear
and tear excepted. The Warranty is valid only if (a) the products are returned to Us for
inspection and testing; (b) Our inspection discloses to Our satisfaction that any alleged
nonconformance are material and have not been caused by misuse, neglect, wear and tear,
improper installation, unsuitable storage, improper repair, alteration, or accident; and (c) the
products were installed, maintained and used in accordance with Our instructions. THE
WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED (OTHER THAN THE WARRANTY OF TITLE AS PROVIDED BY THE
UNIFORM COMMERCIAL CODE IN EFFECT IN MICHIGAN), INCLUDING
WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE, SAID WARRANTIES BEING EXPRESSLY
DISCLAIMED.
2.
Obligations of Purchaser. To make a Warranty claim, contact Us at our principal address of
47912 Halyard Drive, Suite 100, Plymouth, MI 48170, 1-800-632-3290, identify the product
by model number, and follow the claim instructions that will be provided. Any returned
product that is replaced by Us becomes our property. You may be responsible for return
shipping costs. Please retain your purchase receipt to verify date of purchase and that You
are the original consumer purchaser. The product and the purchase receipt must be provided
to Us in order to process Your Warranty claim.
3.
Exclusive Remedy. Product replacement is Your sole and exclusive remedy under this
Warranty. We shall not be liable for service or labor charges incurred in removing or
replacing a product. IN NO EVENT WILL WE BE RESPONSIBLE FOR ANY INDIRECT,
SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES.
4.
Assumption of Risk. You acknowledge and agree that any use of the product for any
purpose other than the specified use(s) stated in the product instructions is at Your own risk.
5.
Governing Law. This Warranty gives You specific legal rights, and You also may have
other rights which vary from state to state. This Warranty is governed by the laws of the
State of Michigan, without regard to rules pertaining to conflicts of law. The state courts
located in Oakland County, Michigan shall have exclusive jurisdiction for any disputes
relating to this Warranty.
Rev 9/2014
Sheet 1 of 18
Scan for safe
towing tip, or visit
http://www.ceque
ntgroup.com/qr-
product.aspx
24941NP
4-14-17
Rev. B

Publicité

loading

Sommaire des Matières pour Cequent Performance Products 24941

  • Page 1 TechnicalSupport@cequentgroup.com LIMITED LIFETIME WARRANTY Limited Lifetime Warranty (“Warranty”). Cequent Performance Products, Inc. ("We", “Us” or “Our”) warrants to the original consumer purchaser only ("You" or “Your”) that the To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE: product will be free from material defects in both material and workmanship, ordinary wear •...
  • Page 2 Scan for step by step ™ Cequent Performance Products, Inc. Installation Instructions PHOTO installation instruction or visit Website: www.cequentgroup.com http://www.cequentg PART NUMBERS: 24941, 77328, CQT24941 roup.com/qr- Technical Assistance: 800-632-3290 product.aspx TechnicalSupport@cequentgroup.com Applications: Installation Time: 45 min Years Make Models The time listed above is the average time for professional installers.
  • Page 3 Authorized Drawbar Kit: Installation Instructions 3593 (Sold Separately) PART NUMBERS: 24941, 77328, CQT24941 Drawbar must be used in the RISE position only. End panel Figure 2 NOTE: Fascia tabs are not centered on vehicle. DO NOT Bumper beam measure from tabs to locate area to trim.
  • Page 4 1b. Remove fascia 1a. Remove fascia using a 7 mm socket, remove (1) screw inside of rear wheel well, using a flat head screw driver, remove (2) plastic retainers at the and (5) screws holding splash guard to fascia, both sides. bottom center of Fascia.
  • Page 5 2. Remove bumper beam – using a 13mm socket with extension, 1e. Remove fascia using a plastic trim panel tool, gently remove the plastic fascia remove (6) flange nuts attaching bumper beam to end panel. starting at the wheel wells first. 3.
  • Page 6 6. Trim fascia – measure, mark, and trim fascia as shown. 5. Tighten all fasteners with torque wrench to 20 Lb.-Ft. (27 N*M) Proper torque is needed to keep the hitch secure to the vehicle when towing. NOTE: Fascia tabs are not centered on vehicle.
  • Page 7 GARANTIE À VIE LIMITÉE Garantie à vie limitée (« Garantie »). Cequent Performance Products, Inc. (« Nous », « Notre ») garantit à l’acheteur initial seulement (« Vous », « Votre ») que le produit sera Pour prévenir les blessures SÉVÈRES, FATALES ou les DOMMAGES exempt de vices de matières et de fabrication, exception faite de l’usure normale.
  • Page 8 Instructions d’installation Numériser pour des ™ Cequent Performance Products, Inc. instructions avec NUMÉROS DE PIÈCES : 24941, 77328, PHOTOS ou visiter Site Internet: www.cequentgroup.com http://www.cequentgr CQT24941 Assistance technique: 800-632-3290 oup.com/qr- product.aspx TechnicalSupport@cequentgroup.com Applications : Durée de l'installation : 45 min Années...
  • Page 9 Ensemble de barre de remorquage Instructions d’installation autorisé: 3593 (vendu séparément). NUMÉROS DE PIÈCE : 24941, 77328, CQT24941 La barre de remorquage doit être utilisée dans la position ÉLEVÉE seulement. Panneau d'extrémité du pare-chocs Figure 2 REMARQUE: les onglets Fascia ne sont pas centrés sur le véhicule.
  • Page 10 1a. Enlever le carénage 1b. Enlever le carénage À l'aide d'une douille 7 mm, retirer une (1) vis à l'intérieur du passage de À l'aide d'un tournevis à lame plate, retirer deux (2) dispositifs de retenue dans le centre inférieur du carénage. roue arrière, et cinq (5) vis qui fixent la bavette garde-boue sur le carénage, des deux côtés.
  • Page 11 Enlever la poutre de pare-chocs – À l'aide d'une douille 13 mm avec rallonge, 1e. Enlever le carénage retirer six (6) écrous à embase qui fixent la poutre au panneau d'extrémité. À l'aide d'un écarteur en plastique, retirer avec précaution le carénage en plastique en commençant par les passages de roue.
  • Page 12 5. Serrer toute la visserie au couple de 20 lb-pi (27 N.m). 6. Découper et réinstaller le carénage et les bavettes garde-boue – Mesurer, marquer et découper le carénage comme illustré à la figure 4. Un couple de serrage adéquat est essentiel pour bien fixer l'attelage au véhicule Réinstaller le carénage et les bavettes.
  • Page 13 CQT24941 GARANTÍA LIMITADA DE POR VIDA Garantía limitada de por vida ("Garantía") Cequent Performance Products, Inc. ("nosotros", Para evitar DAÑOS DE GRAVEDAD, A LA PROPIEDAD O LA MUERTE: "nos" o "nuestro/a/s") garantiza al comprador original únicamente ("usted" o "su/s") que el producto estará...
  • Page 14 Instrucciones de instalación Escanear para ™ Cequent Performance Products, Inc. instrucciones de la NÚMEROS DE PARTES: 24941, 77328, instalación paso por paso Sitio web: www.cequentgroup.com con FOTO, o visitar CQT24941 Assistance técnica: 800-632-3290 http://www.cequentgrou p.com/qr-product.aspx TechnicalSupport@cequentgroup.com Aplicaciones: Tiempo de instalación: 45 min Años...
  • Page 15 Kit de barra de tracción autorizada: Instrucciones de instalación 3593 La barra de tracción (se vende NÚMEROS DE PARTE: 24941, 77328, CQT24941 por separado) se debe usar en la posición levantada únicamente. Panel lateral del parachoques Figura 2 NOTA: Las pestañas de las pestañas no están...
  • Page 16 1b. Desmontar la fascia 1a. Desmontar la fascia con una llave de 7 mm, retirar (1) tornillo en el interior del con un destornillador de cabeza plana, quitar (2) retenedores plásticos en la parte inferior central de la fascia. receptáculo de la rueda trasera y (5) tornillos que sujetan el protector contra salpicaduras con la fascia, en ambos lados.
  • Page 17 2. Desmontar el travesaño del parachoques: con una llave de 1e. Desmontar la fascia con una herramienta de recortar paneles plásticos, retirar 13mm con extensión, retirar (6) tuercas de brida que sujetan la viga del parachoques al panel lateral. suavemente la fascia empezando desde los receptáculos de las llantas primero.
  • Page 18 Recortar y volver a instalar la fascia y los protectores contra 5. Apretar todos los fijadores con una llave de torsión salpicaduras: Medir, marcar y recortar la fascia como se muestra en la a 20 Lb.- pies (27 N*M) figura 4. Volver a instalar la fascia y protectores contra salpicaduras. Se necesita la torsión adecuada para mantener el enganche unido firmemente al vehículo durante el remolque.

Ce manuel est également adapté pour:

77328Cqt24941