Publicité
Les langues disponibles
Les langues disponibles
8558215
LoADING FASTENERS
1.
Connect the tool to the air resource.
2.
Push down on the latch button(B).
Pull back on the magazine cover(C).
3.
For brad nail: Insert a stick of
fasteners into the magazine rail(D).
Make sure the pointed ends of the
fasteners are resting on the bottom
ledge of the magazine when loading.
4.
For staples: set a stick of fasteners on
the top of magazine.
5.
Make sure the fasteners are not dirty or damaged.
6.
Push the magazine cover(C) forward until latch button pops up.
Push
Against
Brad nail Loading way
WARNING: The tool may fire when it is first connected to the air resource. Always connect
the tool to the air resource before loading fasteners to prevent injury from unintended
cycling. Always make sure the tool's magazine is empty at the beginning of each work
session, before connecting to an air resource.
WARNING: Use only those fasteners recommended for use with this tool. Fasteners not
identified for use with this tool by the tool manufacturer are able to result in a risk of injury
to persons or tool damage when used in this tool.
WARNING: Keep the tool pointed away from yourself and others when loading fasteners.
Failure to do so could result in possible serious personal injury.
WARNING: Never load fasteners with the workpiece contact or trigger activated. Doing so
could result in possible serious personal injury.
UNLoADING FASTENERS
Unloading is the reverse of loading. Always disconnect the air resource before unloading.
WARNING: Always unload all fasteners before removing tool from service.
WARNING: Always disconnect the air resource before unloading.
Visit www.princessauto.com for more information
2-in-1 Brad Nailer and Stapler
Nail tips contact
wear rail
Magazine
rail(D)
nose
Latch button
(B)
Staples
Staples Loading way
V 4.0
Magazine
cover(C)
9
Publicité
