Power Fist 8558215 Manuel D'utilisation page 13

8558215
RECOMMENDED HOOKUP
1. The air compressor must be able to maintain a minimum of 60 psi when the
tool is being used. An inadequate air supply can cause a loss of power and
inconsistent driving.
2. An oiler can be used to provide oil circulation through the tool. A filter can be used to
remove liquid and solid impurities which can rust or gum up internal parts of the tool.
3. Always use air supply hoses with a minimum working pressure rating equal to or
greater than the pressure from the power source if a regulator fails, or 150 psi,
whichever is greater. Use 3/8 in. air hose for runs up to 50 feet and use 3/8 in. quick
coupler on the air hose.
4. Use a pressure regulator on the compressor, with an operating pressure of 0 to
125 psi. A pressure regulator is required to control the operating pressure of the tool
between 60 and 110 psi.
CAUTION: The air compressor must be able to maintain a minimum of 60 psi when the tool is
being used. An inadequate air supply can cause a loss of power and inconsistent driving.
WARNING: Do not connect with an air compressor which can potentially exceed 200 psi. As
tool may burst, possibly causing injury.
Quick
Coupler
Quick
connector
Visit www.princessauto.com for more information
2-in-1 Brad Nailer and Stapler
Quick
Air hose
connector
Quick
Coupler
Filter
Oiler
Regulator
V 4.0
Compressor
13