Installing Accessory Bag; Wet/Dry Vac Assembly - Workshop WS1400CA0 Manuel Du Propriétaire

DRUM/CADDY ASSEMBLY (continued)

Installing Accessory Bag

Install accessory bag as shown with
extension wand holders facing unit.
1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum

WET/DRY VAC ASSEMBLY

Drum
Latch
Drum
Flange
Accessory Bag Snaps
Insert Hose
Insert the push button end of the Dual-Flex™
Locking hose into the inlet of the Vac. The
hose should snap into place. To remove the
hose from the Vac, press the release button in
the hose assembly and pull the hose out of the
Vac inlet, as shown.
Press
and
Pull
9
Accessory
Bag Straps
(4)
Handle
Release
Button