Emptying The Drum; Blowing Feature; Maintenance; Filter - Workshop WS1400CA0 Manuel Du Propriétaire

Emptying the Drum

WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
1. The Vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the
drum.
2. Another option is to remove the
powerhead assembly.
3. Lay powerhead assembly aside on a
clean area while emptying drum.
4. Dump the drum contents into the
proper waste disposal container.

Blowing Feature

Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.

Filter

WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
OPERATION (continued)

MAINTENANCE

CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended hours or when using in a
noisy area.
1. Locate blowing port of your Vac.
2. Insert the locking end of the Dual-
Flex™ Locking hose into the blowing
port of the Vac. The hose should snap
into place. To remove the hose from the
Vac, press the release button in the
hose assembly and pull the hose out of
the Vac inlet.
3. (Optional) Attach extension wand to
opposite end of hose, then place the
car nozzle on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Dual-Flex
Locking
Hose
Extension
Wand
(Optional)
NOTE: The filter is made of high quality
paper designed to stop very small particles
of dust. The filter can be used for dry debris
or small amounts of liquid. Handle the filter
carefully when removing to clean or
installing it. Creases in the filter pleats may
occur from installation but not affect the
performance of the filter.
13
Blowing
Port
Swivel End
of Hose
Car Nozzle
(Optional)