Accessory Storage & Assembly; Cord Wrap; Locking Sleeve - Workshop WS1400CA0 Manuel Du Propriétaire

ACCESSORY STORAGE & ASSEMBLY
Your accessories may be stored in the
removable accessory bag, or in the two
locations on the caddy right/left. Either
the hose or the wands may be stored in
the two areas marked Hose Storage.
The hose may be stored by wrapping it
around the unit and plugging the open
end into one of the storage locations on
the caddy assembly. Alternatively, the
wands may also be stored in this location
by plugging either of the ends of the
wands onto the storage receivers located
on the caddy.

Cord Wrap

When vacuuming is complete, unplug the
cord and wrap it around the power
assembly as shown. The cord should
wrap under the pull handle (above the
inlet) and around and under the cord
wrap of the motor cover.
S E
H O E
A G
O R
S T
Hose Storage
Area
Accessory Bag
Push/Pull Handle

Locking Sleeve

The Locking Sleeve is designed to
provide added strength in accessory
connections.
The Locking Sleeve can be used when
connecting:
• Extension wand to extension wand
(shown)
• Hose to extension wand
• Extension wand to nozzle
To install the Locking Sleeve: slip Locking
Sleeve over accessory end, roll sleeve
back to expose accessory end, attach
accessory and unroll sleeve over
attached accessory.
Extension Wand
Locking Sleeve and Extension
Wands Engaged
10
Cord Wrap
Power
Cord
Extension
Wand
Locking Sleeve
Locking Sleeve
Rolled Back