Electrical Connection; Before Operation - Sinmag Europe Divo Mode D'emploi

ENG

3.5 Electrical connection

1.
An electrical supply should be available within the reach of the included power cord.
Do not use extensions to connect the machines power cord to the electrical supply.
2.
Before making the electrical connections, read the specifications on the rating plate
to ensure that they comply with those of the electrical supply. Electrical connection
should be made by a qualified service technician who will observe all applicable
safety codes and the national electrical codes.
When connecting this machine to the mains supply, ensure that the following is carried
out:
1.
An isolating switch is fitted within 2m of the machine.
2. A grommet is fitted around the power supply cord entry hole into the machine.
3.
All wiring connections must be checked and tight.
Once the electrical connection has been made, the Hydraulic Divider is ready for use.
Electrical Supply Requirements 380VAC, 50Hz, 3PH+E.
4. OPERATION

4.1 Before operation

Before starting the machine, carry out a general safety check:
1. Check the machine is clear of all objects, all switches are off and any danger
area is clear of bystanders.
2. Area must be clean and free from obstructions, e.g. nothing placed in the divid-
ing bowl.
3. Check or place the electrical cord in the appropriate socket and turn power 'On'.
4.2 Operation Switches
1
Emergency Stop Switch: Press this button when there is anything emergency.
1
Up Switch: Keep pressing this button to lift the knives and pushers.
2
Down Switch: Keep pressing this button to low down the knives and pushers.
3
Blade Lift System: Keep pressing button 2 & 4 concurrently to lift the blades.
4
6
2 3 4
SINMAG EUROPE BVBA