Inserting The Hood Canopy Into The Support Surface From Above; Fixing The Lower Brackets - Faber Scirocco Lux SCLX3015BKNB-B Instructions D'installation Et Guide D'utilisation Et D'entretien

Inserting the Hood Canopy into the support surface from above

3
Inserting the Hood Canopy into the countertop from above
• Insert the Brackets 7.2, as
indicated in the figure, into the
slots provided and fix them with
the screws 12a provided.
• Insert the Brackets 7.2, as
• Insert the Brackets 7.2, as
indicated in the figure, into the
indicated in the figure, into
slots provided and fix them with
the slots provided and fix them
the screws 12a provided.
with the screws 12a provided.
• Insert the Hood Canopy into the
cooker top, drilled as described
above.
• Insert the Hood Canopy into the
• Centre the Hood Canopy with
countertop, drilled as described
• Insert the Hood Canopy into the
respect to the Cooking Hob slot.
above.
cooker top, drilled as described
• Fix the Hood Canopy with the 2
• Center the Hood Canopy with
above.
screws 12c provided.
respect to the cooktop slot.
• Centre the Hood Canopy with
• Secure the Hood Canopy with
respect to the Cooking Hob slot.
the 2 screws 12c provided.
• Fix the Hood Canopy with the 2
screws 12c provided.
Warning:
If the countertop is made from a material that does not allow the screws 12c to be inserted,
use a small amount of silicone to glue the Brackets 7.2 to the top and allow it to dry completely
before proceeding with installation.
Warning:
If the cooker top is made from a material that does not allow the screws 12c to be inserted, use
4
• Screw the brackets 7.1 to the front of the Hood Canopy using the screws 12a provided.
a small amount of silicone to glue the Brackets 7.2 to the top and allow it to dry completely
• Before tightening the Brackets completely, make all the adjustments to allow them to rest on
Warning:
before proceeding with installation. • Screw the brackets 7.1 to the front of the Hood Canopy using the screws 12a provided.
the lower base of the worktop to avoid deformation of the upper brackets 7.2 as shown in the
If the cooker top is made from a material that does not allow the screws 12c to be inserted, use
• Before tightening the Brackets completely, make all the adjustments to allow them to rest on
figure.
a small amount of silicone to glue the Brackets 7.2 to the top and allow it to dry completely the lower base of the Cabinet Base to avoid deformation of the upper brackets 7.2 as shown
in the figure.
before proceeding with installation.
12a
EN
EN
• With the aid of a spirit level, set the Hood Canopy level vertically and fix it to the Lower
8
Surface using 2 screws 12c provided.
7.2
12a
7.2
12a

Fixing the Lower Brackets

Securing the Lower Brackets
7.1
12a
7.1
7.2
7.2
12a
12a
2 25
2 25