Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fixing the Electric Unit
8
• Connect the wires coming out of the bottom right part
of the Hood Canopy to the corresponding connector
on the Electric Unit, taking care not to make any
wrong connections. Check the picture below.
9 poles System
Connector
Connect the ductwork to the damper and seal all connections with duct tape.
Turn the power supply on. Turn on the blower and light. If the rangehood does not operate, check that
the circuit breaker is not tripped or the house fuse blown. If the unit still does not operate, disconnect
the power supply and check that the wiring connections have been made properly.
"GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape wire for the electric current. This appliance is
equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged
into an outlet that is properly installed and grounded.
WARNING - Improper grounding can result in a risk of electric shock.
Consult a qualified electrician if the grounding instructions are not completely understood, or if
doubt exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician
install an outlet near the appliance."
Warning..: Do not install the product in such a way that the electric unit is in contact with the floor.
14
Installation of Electrical Module
Command Flat
Connector
Blower Connector
Power supply
• Secure the Electric Unit to the Hood Canopy using the
screws 12a provided.
• The Electric Unit can be installed on the left or right of the
front of the hood canopy as shown above. It can also be
installed on the cabinet base if space allows.
2
Publicité
Table des Matières
