Cleaning and Maintenance
Problems
Function display
13
No steam comes out of
the steam jets
.
20
Sudden increase in the
volume coming from the
pump
Water is flowing from
the steam jets
.
20
The turbo brush
18
does not turn
44 GB
114903_silv_Dampfbesen SDB 1500 A1_content_DE_AT_CH.indd 44
Causes
off.
Mains plug
not connected. Check that the mains plug
4
Steam button
has not been
16
pressed.
The device is not ready for
operation.
No water in the water tank
Water tank
has not been
11
correctly inserted.
The steam vents may be
blocked by limescale.
No water in the water tank
Water tank
has not been
11
correctly inserted.
Possible residual condensation
in the steam tube
The ON/OFF button
not been pressed.
Solution
correctly.
Check that the cable is supplied with power.
Please try plugging the mains plug
other socket. Should the problem still persist,
please consult one of the afore mentioned
service centres (refer to "Service" chapter).
Press the steam button
Press the steam button
30 seconds. If no steam is produced after
this time, please consult one of the afore
mentioned service centres (refer to "Service"
chapter).
. Fill the water tank
11
the thread.
Remove the water tank
again. Check that it is seated correctly.
Please consult one of the afore mentioned
service centres (refer to "Service" chapter).
. Switch off the device and fill the water tank
11
with water.
11
Remove the water tank
again. Check that it is seated correctly.
Press the steam button
steam comes out. Place a cloth under the
device to ensure that the floor does not
become wet. If water continues to flow from
the device, switch off the device. Wait for at
least 5 minutes until the steam base
the pad
have been allowed to cool. Try
8
again.
has
Press the ON/OFF button
5
the problem still persist, please consult one
of the afore mentioned service centres (refer
to "Service" chapter).
is plugged in
4
into an-
4
.
16
for approximately
16
to the lower edge of
11
and put it in
11
and put it in
11
until no more
16
and
9
firmly. Should
5
09.06.15 08:55