Steba VDM 2 Hot & Cold Mode D'emploi page 19

Usage
∙ Never leave the appliance running unfilled, as this can cause the bearings to
overheat.
∙ Only fill the appliance with food and liquids up to max. 600ml. The minimum filling
quantity is 200 ml (see scale on the appliance).
∙ The appliance is not suitable for dry mixing, grinding or pulverising.
∙ For safety reasons, the lid must always be
placed correctly on the jug (see picture).
If the lid is not placed correctly, the appli-
ance will not start and 'Cover the Lid' will
appear in the display.
∙ Always place the jug on the motor part with the
handle to the right.
∙ Connect the appliance, a signal can be heard and the display lights up "short press
turn on".
∙ Press the knob 6), the standard programme SOYA lights up.
∙ With the control dial 6) you can select the different programmes.
∙ Put the ingredients into the appliance and start the programme by briefly pressing
the knob 6).
∙ After the time has elapsed, a beep sounds and "SOYA complete" is shown in the
display.
∙ If an ingredient is to be added while the programme is running, open the lid. The
machine beeps and says "Cover the Lid". Add the ingredient and replace the lid as
described above, the programme will continue.
∙ If the programme is to be ended prematurely, press and hold knob 6) for 3 seconds.
∙ Note: when preparing hot dishes, the cooking time starts to run after the
cooking temperature has been reached.
∙ Let the appliance cool down for a few minutes before starting a new programme.
19