Snapper 7800849B Manuel D'installation page 10

5
Propelling the Mower
1. Start the mower.
2. Move the ground speed control (A, Figure 6) to the
desired speed position.
3. Squeeze the wheel drive control (B) against the handle
to engage the wheel drive and propel the mower forward.
Forward speed can be adjusted while the mower is
moving by changing the position of the ground speed
control.
6
Stopping the Mower
1. Stop forward motion of the mower by releasing the wheel
drive control.
2. Stop the engine and blade by releasing the blade control.
10
Handle Height Adjustment
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or
service with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
The height of the mower handle can be adjusted as follows:
1. Loosen the lower nuts (A, Figure 7) on each lower
handle.
2. Move the handle assembly (B) up or down until the
desired position is achieved.
3. Tighten the lower nuts on each lower handle to maintain
the desired position.
7
www.snapper.com