Ec Declaration Of Conformity - IKRA BF 33 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

RECTIFYING MOTOR FAULTS

PROBLEM

The motor does not start, or starts

but does not continue to run.

The motor starts but will not run at full

power.

Motor runs unevenly.

Excessively high noise.

We, ikra GmbH, Schlesier Straße 36, D-64839 Münster, declare under our sole responsibility that the product pet-

rol brushcutter BF 33, to which this declaration relates correspond to the relevant basic safety and health require-

ments of Directives 2006/42/EC (Machinery Directive), 2014/30/EU (EMC-Guideline), 97/68/EC as amended by

2004/26/EC (emmission directive, Anex IV) and 2000/14/EC (noise directive). For the relevant implementation of the

safety and health requirements mentioned in the Directives, the following standards and/or technical specification(s)

have been respected: EN ISO 11806-1:2011, EN ISO 14982:2009

measured acoustic capacity level [dB(A)]

guaranteed acoustic capacity level [dB(A)]

Conformity assessment method to annexe V / Directive 2000/14/EC

The year of manufacture is printed on the nameplate and can be additionally retrieved via the consecutive serial number.

Münster, 21.04.2016

Maintenance of technical documentation: Gerhard Knorr, Kärcherstraße 57, DE-64839 Münster

POSSIBLE CAUSE

Incorrect start procedure

Incorrectly set

fuel/air mix on carburettor.

Rusted spark plug

Blocked fuel filter.

Incorrect choke lever position.

Dirty air filter

Incorrectly set

fuel/air mix on carburettor.

Incorrectly set spark gap

on spark plug.

Incorrectly set carburettor

Incorrect fuel mixture.

Incorrectly set carburettor