Installation - Progress PG0853 Notice D'utilisation

Problem
Door does not open easily.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Closing the door
1. Clean the door gaskets.

INSTALLATION

WARNING! Refer to Safety
chapters.
Location
Refer to the assembly
instructions for the installation.
To ensure best performance, install the
appliance well away from sources of heat
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate freely
around the back of the cabinet.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Cli- Ambient temperature
mate
class
SN +10°C to + 32°C
Possible cause
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
You attempted to re-open
the door immediately after
closing.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
Cli-
mate
class
N
ST
T
Ventilation requirements
The airflow behind the appliance must be
sufficient.
Solution
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.
Wait a few seconds between
closing and re-opening of the
door.
Ambient temperature
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation
can only be guaranteed within
the specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer service
or to the nearest Authorised
Service Centre.
Progress 23