Progress PG0853 Notice D'utilisation page 22

22 Progress
Problem
The compressor operates
continually.
There is too much frost and
ice.
The temperature in the appli-
ance is too low/too high.
Possible cause
The appliance is not working
properly.
The temperature in the appli-
ance is too high.
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
Solution
Contact a qualified electrician
or contact the nearest Au-
thorized Service Centre.
Contact a qualified electrician
or contact the nearest Au-
thorized Service Centre.
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.