Ws2 (×6); Wa1 (×4); Ww1 (×6) - Sony SU-WL855 Informations D'installation

Installing the Wall-Mount
Bracket to the Wall
1
Decide on the installation
location.
Make sure that the wall has enough space
for the TV and is capable of supporting a
weight of at least six times that of the TV.
• Refer "Measurement for Wall-Mount
Bracket installation on the wall" on page
21.
• Refer to your TV's Reference Guide for the
TV's weight.
Note
 When your TV is installed on the wall, the upper
side of the TV slightly leans forward.
 We recommend you to check the position of TV in
the viewing environment.
2
Align to the wall and make
WM1
four marks.
× 4
Note
 Use a level to check whether
WM1
WM1
is level.
− 14 (US) −
3
Drill pilot holes on the marks.
Note
 Pilot holes must be drilled to a depth of 75 mm
(3 inch), using a 10 mm (13/32 inch) diameter drill
bit.
4
5
Install on the wall.
WM1
Note
 Use a level to check whether
Precaution
 Do not over-tighten the lag bolts
tightening could reduce the holding power of the
WS2
lag bolts .
× 4
10 mm
(13/32 inch)
75 mm
(3 inch)
WA1
WW1
WS2
WM1
is level.
WS2
. Improper