Preinstallation; Preparing The Cabinet; Cutting The Opening - Dometic CRG 3000 Serie Manuel D'installation Et D'utilisation

CRG 3000 Series Range
Figure 1 provides an example of the CRG 3335 model
light wiring.
y
t
1 Wiring Diagram
Oven Lamp
q
Patch Board
w
Lamp Switch
e

6 Preinstallation


WARNING: FIRE HAZARD.
Failure to obey the warnings or preinstallation
instructions in this section could result in property
damage, death, or serious injury.
This section provides information on preparing the
cabinet and opening for the range installation.

6.1 Preparing the Cabinet

For proper range operation, the cabinet must:
• Be properly constructed.
• Be squared to the counter top and cabinet face.
EN
q
GND
12 VDC
e
w
r
Ignition Pins
r
Igniter
t
Lamp Panel
y
For proper range operation, the cabinet opening must:
• Be level from side-to-side and from front-to-rear.
• Be free from gaps between the range and any
adjacent cabinet.
• Meet the minimum clearances to combustibles.
• Be positioned so that combustible material cannot be
placed next to the range sides.
• Applies to the CRG 3335 model only: Provide DC
electrical supply conductors with strain relief at the
range.
• Be framed-in or guarded to prevent the creation of
storage space around the recessed portion of the
range, except for the vent thimble.
• Have closed openings around the gas and electrical
service outlets at the time of installation, except
where the construction of the range provides the
necessary closure.
• The range must be completely separated and/or
sealed from the other air moving or air-consuming
devices such as, but not limited to, furnaces,
microwave ovens, clothes dryers, cooling fans, and
doors or drawers in common cabinets. If not, it can
affect the appliance(s) combustion air supply by
creating either a negative or positive draft.

6.2 Cutting the Opening

1. Before cutting the opening, perform the following
checks:
– Verify the cutout location.
– Verify that the cutout dimensions and clearances
match those indicated in Figure 2 and Figure 3.
– Confirm a propane-certified gas line is in place
that meets the appropriate RV and gas codes.
2. Cut the hole for the range.
Preinstallation
5