Removing Or Reinstalling The Oven Door; Checking The Burner Flames And Oven; Burner; Replacing The Oven Light - Dometic CRG 3000 Serie Manuel D'installation Et D'utilisation

Maintenance
2. Locate the screws securing the cover to the range.
3. Loosen screws and remove them from the mounting
holes.
4. Carefully lift the glass bi-fold cover off of the range
and place it in a flat, secure area.
5. Reverse these steps to reinstall the glass bi-fold cover.
I When attaching the glass bi-fold cover, always
carefully open and close the cover to verify it is
secured properly and will not break free from the
range.
9.2 Removing or Reinstalling the
Oven Door

CAUTION: ELECTRIC SHOCK, BURN, CUT
AND/OR BROKEN LIMB HAZARD. Failure to
follow the following warnings could result in
minor or moderate injury:
• Make sure the oven is cool and the power to the oven
has been turned off before removing the oven door.
The oven door is heavy and fragile.
• Use both hands to remove the oven door. The
oven door front is glass. Handle it carefully to avoid
breaking the oven door.
• Grasp only the sides of the oven door. Do not
grasp the handle as it may swing in your hand
uncontrollably and cause damage.
• To avoid injury from the hinge bracket snapping
closed, be sure that both levers are securely in place
before removing the oven door.
• Do not force the oven door open or closed.
I The oven door is heavy. Consider getting another
person to help remove or place the oven door, if
needed.
1. Open the oven door all the way.
2. Flip the hinge levers (one on each side) forward
(toward the oven door).
3. Push the oven door closed until it stops. It will be
about halfway open.
14
4. Holding it firmly on both sides and using both hands,
pull the oven door straight out of the hinge slots.
5. Place the oven door in a flat, secure location.
6. Reverse these steps to reinstall the oven door.
9.3 Checking the Burner Flames and
Oven Burner
1. Light the cooktop burners, one at a time. See
"Lighting the Cooktop Burners" on page 11.
2. Confirm that the cooktop burner flames are present
and adjust when the cooktop burner control knob is
turned.
3. Light the oven pilot. See "Lighting the Oven Burner"
on page 12.
4. Confirm the pilot flame is present and the oven
burner adjusts when the oven control knob is turned.

9.4 Replacing the Oven Light

I Applies to the CRG 3335 model only.
1. Turn off the main power supply or unplug the range if
the plug is accessible.
2. Remove the glass cover over the light bulb.
3. Remove the light bulb.
4. Replace the light bulb with one rated for:
– Temperatures: up to 572 °F ( 300 °C)
– Voltage: 12 V
– Wattage: 15 W
– Type: G9
5. Replace the light bulb cover.
6. Reconnect the range to the main power supply.

9.5 Replacing the Control Knob LED

I Applies to the CRG 3335 model only.
Call Dometic Customer Service to replace control knob
LED lights.
CRG 3000 Series Range
EN