Lighting The Oven Burner; Extinguishing The Flame; Operating The Oven Light - Dometic CRG 3000 Serie Manuel D'installation Et D'utilisation

Operation
1. Turn all cooktop control knobs to the off position.
2. Turn on the gas supply.
3. If the range is equipped with a glass bi-fold cover,
raise it before using the cooktop.
4. Select a cooktop burner to light. Do not attempt to
light more than one cooktop burner at a time.
5. Push in the selected cooktop burner's control knob
and turn it counterclockwise until it points to the
lightning bolt decal.
6. Turn the igniter control knob clockwise until there is
an audible click. Continue turning it until the cooktop
burner ignites, then release the igniter control knob.
7. Repeat steps 4–6 as needed for other burners.
8. Push the burner control knob in and turn it to adjust
the flame to the desired level.

8.3 Lighting the Oven Burner

13 Lighting the Oven Pilot
Igniter Control Knob
q
1. Turn all control knobs to the off position.
2. Turn on the gas supply.
3. Push in, hold, and turn the oven control knob
counterclockwise until it points to the pilot position.
12
q
Oven Control Knob
w
4. While continuing to push and hold the oven control
knob in, turn the igniter control knob clockwise until
there are audible clicks. Continue these actions until
the burner ignites.
5. Release both control knobs and verify that the burner
stays lit.
6. Repeat steps 3–5 if the pilot extinguishes.
The oven burner has been factory set and requires
I
no further adjustment.

8.4 Extinguishing the Flame

Turn the active cooktop and/or oven control knobs
clockwise to the off position.

8.5 Operating the Oven Light

Applies to the CRG 3335 model only.
I
w
14 Oven Light Switch
To turn the oven light on, push the rocker switch on the
front panel to one of three positions:
– Turn on oven light and control knob lights
– Turn off the oven light and control knob lights
– Turn on the control knob lights only
CRG 3000 Series Range
EN