Publicité
Les langues disponibles
Les langues disponibles
Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante - Fabricante
16. TANK CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
By tank cleaning, proceed as follows:
1.
Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves.
2.
Before cleaning the tank the inside temperature must be equal to the ambient temperature;
3.
Extract the plate, taking care to hold it as horizontal as possible to prevent any dirt from falling into the compartment below.
4.
Wash the plate with water and mild soap, rinse it and carefully dry it with a soft cloth.
5.
Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and fresh water.
6.
Clean the height adjusters supporting the levels with a jet of air.
7.
Clean the surfaces with a cloth, using neutral PH detergent, rinse and dry.
8.
Avoid water entering into the appliance lighting units.
9.
Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the
cabinet.
The water generated by the evaporator, collected in a tray, soaks an absorbent
cloth and is dissolved by means of the heat lost by the cooling system.
Periodically check and clean the tray,removing dust and/or residues,
after extracting the support of the absorbent cloth.
WARNING! Do not use jet of water to clean the cabinet: electrical
wiring could be damaged.
WARNING! Never use mechanical devices or any other
means to accelerate the defrosting process, other than those
recommended by the manufacturer.
17. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate pre-established
temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
•
Press the (C) key in order to see on display the temperature set point.
•
Press the (A) key or the (B) key in order to increment or decrement the temperature set point
•
Press the (C) key in order to store the new temperature set point.
JOY 30 LITE
JOY 30 PRIME
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
A
B
Electronic control
A)
Button to increase temperature
B)
Button to decrease temperature
C)
Button to show set temperature
D)
Automatic defrosting button (press for defrosting start)
E)
Light switch
E
C
D
1 8 / 6 0
PAGE
UM000368
N° DOC
Publicité
