Publicité
Les langues disponibles
Les langues disponibles
10. Applicable regulations
Manufacture in accordance with the following safety regulations
EN 6110-1 (Safety requirements for electrical equipment for measurement, control
and use in laboratories - Part 1 / general requirements)
UL 3101-1 (Electrical equipment for laboratory use - Part 1: General requirements)
CAN/CSA C22.2 (1010-1)
EN 61010-2-10 (Heating)
Manufacture according to the following EMC regulations
EN 61326-1 (Electromagnetic Compatibility)
Associated EU Directives:
EMC Directive: 89/336/EWG
Instrument directive: 73/023/EWG
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested to comply with the limits for an electrical device of class A with
compliance with part 15 of the FCC rules. These limits are designed to provide protection against interference
when the equipment operates in a commercial environment. This equipment generate, uses and can radiate radio
frequency energy, therefore, if it is not installed and used in accordance with this instruction manual, it may cause
interference in radio communications. Using this equipment in residential areas could cause harmful interferences,
in this case, the user will have to correct these interferences on their own.
11. Storage and transportation
This chapter introduces you on how to pack away the instrument, how to prepare it for transport, specific
storage and transport conditions.
Attention
-Electronic devices cannot be cleaned with
cleanser
-If you require maintenance service, the
instrument must be cleaned before shipment to
avoid pollution of hazardous substances and
also to be sent back in the original packaging.
-If the instrument will not be used for a long
time, please, switch off and store it in a dry and
clean place with a steady room temperature.
Table 9
21
Publicité
