LBX instruments EVA180 Mode D'emploi page 10

5.1.3 Adjusting the angle of rotation
-Using the knob (D), you can adjust the rotation angle of the evaporating flask. Turn the key
anticlockwise to modify the rotation angle.
-Adjust, by hand, an angle of approximately 30°.
-Once the angle is fixed, close the key (D) by turning it clockwise. In this way, we hold the body that
contains the glass parts
5.1.4 Steam step piece
To insert the evaporator tube (E), proceed with the following instructions:
-Open the locking device (F) by unscrewing the 4 screws located on the main unit by turning
counterclockwise
-Insert the evaporator tube until it stops
-Open the locking device on the drive head by turning it 60°counter clockwise (E), (Figure 9)
-Feed the steam pipe in until it stops
-Then lock the locking device by turning it clockwise by 60°
-Close the blocking device by turning it clockwise and inserting again the 4 screws for a better seal
The plastic screw nut (F) helps to create a hermetic seal without tensioning the contact part.
-To install the nut, it is only necessary to insert it through the evaporation tube and screw it in clockwise.
Attention!
Make sure the required voltage coincides with
electric supply
Connect the instrument to a grounded power
source
Figure 8
Figure 9
10
D
E
F