Publicité
Les langues disponibles
Les langues disponibles
5.1.5 Condenser board
The condenser gasket allows the hermetic seal and guarantees the vacuum of the equipment. It is located
in the contact part with the condenser. To install it, observe the following images:
Note: Prior to commissioning, hand-tighten the plastic screw nut (F) left-aligned.
Installing condenser seal (Figure 10 and Figure 11):
Note: Chapters 5.1.2 and 5.1.3 they do not require installation because they have already been mounted at
the factory. It is only necessary to perform this installation when you want to make a change of accessories in the
equipment or maintenance. See list of accessories in chapter
5.1.6 Condenser
-Insert the nut (H) first and place the locking spring (I) into the condenser
-Once the assembly is done, place and install it in the main body by turning the nut (H) clockwise
-To make a better seal, turn on the equipment and rotate at 200 rpm for 2 minutes.
Figure 12
Figure 10
G
H
I
Figure 11
"9: Accessories and spare
Figure 13
11
parts".
H
Publicité
