EUROM Safe-t-Convect Manuel D'utilisation page 27

After operation
CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
1. Make sure the ON/OFF switch is in the OFF position (Figure 10, pos. 1).
2. Disconnect the power plug from the power outlet (Figure 10).
3. Let the device cool down before touching it.
4. Wind the power cable.
5. Remove the batteries from the remote control (Figure 11).
Maintenance
WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the
electric cable and/or electric plug are damaged, it should be replaced by the manufacturer or
its service employee or persons with similar qualifications to prevent risks.
Cleaning
WARNING
The device becomes very hot. Make sure the device is turned off, unplugged
and completely cooled down.
CAUTION
Do not use:
•
•
•
Prevent water from entering the device. Do not immerse any part of the device
in water or other liquids.
It is recommended to clean the device after each use and prior to storage.
1. Carefully vacuum the openings to remove dust and dirt.
2. Wipe the device with a damp, clean, soft, lint-free cloth or a soft brush.
3. Let the device dry completely prior to use and storage.
Disposal
At its end of life, discard the device according to the local laws and
regulations, or deliver the device to your supplier. Remove the batteries
from the remote control for separate disposal
scouring pads;
hard brushes;
flammable, aggressive or chemical cleaning products.
27