EUROM Safe-t-Convect Manuel D'utilisation page 24

1. Make sure the device is correctly assembled.
2. Make sure the ON/OFF switch is in the OFF
position (Figure 10, pos. 1).
3. Place the power plug (Figure 10, pos. 2) into
an earthed wall socket that is easily
accessible. Use an earthed wall socket with a
minimum power of 2400 Watt.
Remote control
1. Remove the cover (Figure 11, pos. 1).
2. Remove the batteries (if present).
3. Insert two batteries (AAA 1.5 V) (Figure 11,
pos. 2) as indicated in the battery
compartment. Make sure to insert the
batteries correctly.
4. Replace the cover.
Operation
WARNING
Before every use, make sure that:
•
•
•
•
•
CAUTION
When the device is turned on or off, it may emit a sound. This is material
expanding and shrinking during heating and cooldown.
24
you operate the device with dry hands;
the device is clean and dry;
the device is not damaged;
the device is not covered or blocked;
the device is securely installed.
Figure 10
Figure 11