EUROM Safe-t-Convect Manuel D'utilisation page 25

1. Set the ON/OFF switch to the ON position
(Figure 12, pos. 1).
2. The display (Figure 12, pos. 2) will show OFF.
3. Press the ON/OFF button. The device will
always start in P-mode, the SET temperature
starts at 20 degrees Celsius and High heating
capacity. Display shows the room
temperature.
CAUTION
The display shows the ambient temperature. After you set the desired
temperature, this flashes on the display five times. Then the display shows the
ambient temperature again..
Manual mode
1. Press the Mode button to choose the manual mode.
2. Set the capacity at which the heater will work using the plus and minus button on the
control panel or the heating capacity button on the remote control. The 3 sun symbols
indicate whether the heater is set to low, medium or high capacity.
Program mode
1. Press the Mode button to choose the program mode.
2. Set the desired temperature for the device using the plus and minus button on the
control panel or the remote control. The device automatically:
•
turns the heating element off when the desired temperature is reached;
•
turns the heating element back on when it cools down.
3. Set the capacity at which the heater will work by using the Mode button on the control
panel or the max button on the remote control. It will switch the setting in following
sequential default order:
•
P-mode: high capacity;
•
P-mode; medium capacity;
•
P-mode: low capacity;
•
P-mode: high capacity;
•
etc.
Figure 12
25