Hendi 860502 Mode D'emploi page 9

This soup kettle saves up to 30% on energy costs compared to traditional soup
kettles (like Hendi 860083)*
Hendi Soup kettle Eco 860502
Hendi Soup kettle 860083
*Indoor use, ambient temperature of 25 °C, lid closed and water pan filled to at least the minimum water level
mark.
Preparations before using for the first time
•
Check to make sure the appliance is undamaged. In case of any damage, contact your supplier
immediately and do NOT use the appliance.
•
Remove all the packing material and protection film (if applicable).
•
Clean the appliance with luke-warm water and a soft cloth.
•
Place the appliance on a level and steady surface, unless mentioned otherwise.
•
Make sure there is enough clearance around the appliance for ventilation purposes.
•
Position the appliance in such a way that the plug is accessible at all times.
Important
• Always ensure that there is sufficient water in the inner pot. Check this regularly, also during use.
Maintenance advice
• Always remove the plug from the socket before cleaning.
• If used intensively, regularly remove lime scale from the bottom of the water tank
• Never immerse the appliance in water or any other cleaning fluid
• Clean the appliance with a damp cloth
• Never use aggressive, corrosive cleaning agents or abrasives. Do not use any sharp or pointed
objects. Do not use petrol or solvents! Clean with a damp cloth and detergent if necessary. Do
not use abrasive materials.
• Avoid water contact with the electrical components as much as possible
Faults
Fault
Appliance does not work
Appliance does not reach
the set temperature
Buzzer alarms
Technical data
Input Voltage
Power
Capacity:
Possible cause
No power at the socket
The plug is not plugged (correctly)
into the power point
Heating element faulty
Control unit faulty
Heating element fuse faulty
Heating element overheat
220-240 V a.c./50 Hz
450W
8 Litres
Consumption per hour
125 kWh
160 kWh
Possible solution
Check the fuse
Check the plug
Contact the supplier
Contact the supplier
Contact the supplier
First, check if water level is
below the "MIN" mark.
If alarm is still ON after cool
down, contact the supplier for
aftersales service.