Managing Connections; Quality Checks; Self-Tests; Status Indicator - Nikon OPTOS Monaco P200TE Manuel D'utilisation

3.4.5 Managing connections

The ability to edit network settings is restricted to System Administrators.
If there are any connection problems ask your System Administrator to review your settings and where
necessary contact your Optos representative for instructions on how to proceed, see Contact us on page 71 .

3.4.6 Quality checks

Your system automatically runs specific checks during start up and shut down.

3.4.6.1 Self-tests

Each time the system starts it runs a series of self-tests. If any problems are identified please follow the on-
screen instructions and take appropriate action or contact your Optos representative, see Contact us on
page 71 .

3.4.6.2 Status indicator

The status of the scan head is identified using different colored lights on the status indicator. For more
information see System parts on page 23 .

TABLE 5: List of status indicator lights

Status color
White
Green
Yellow
Blue

3.4.6.3 Software update

Each time your scan head shuts down it will check for software updates.
Please allow up to 15 minutes for the update to complete. You will be instructed when it is safe to switch off.
Do accept updates when you are about to image a patient.
NOT

3.4.7 Maintenance

User maintenance is restricted to cleaning and visual checks for external damage.
Your device will be installed by Optos trained personnel. Do
they have completed the installation and training.
Your Optos representative will configure the settings when the device is installed. These
settings should
Please consult your Optos representative before changing the settings.
CAUTION
Do
NOT
permitted to service the device.
The scan head weighs 40 kg (89 lbs). This requires two people to lift or carry the unit.
You should be aware of your contractual obligations before disposing of any equipment.
Part Number: G108707/8GWE
Copyright 2018, Optos plc. All rights reserved.
Description
Switching on and running self-tests
Ready for use
System error
System in standby mode
be changed in the course of normal operation.
NOT
remove the scan head covers. Only Optos trained technical personnel are
Chapter 3 - How to...
operate the device until
NOT
Page 55 of 76
English