Breville the Infuser Manuel D'instructions page 30

TROUBLESHOOTING PAGE HEADER.....
PROBLEM
Machine does not
heat up.
STEAM/HOT WATER
light flashes when the
machine is turned
On.
Water does not flow
from the group head.
No hot water.
Espresso only drips
from the portafilter
spouts.
30
POSSIBLE CAUSES
• STEAM/HOT WATER dial
is not in the STANDBY
position.
• Machine has not reached
operating temperature.
• Water tank is empty.
• Water tank is not fully
inserted and locked into
position.
• Machine needs to be
decalcified.
• Coffee is ground too finely
and/or too much coffee in
filter basket and/or over
tamping.
• Coffee is ground too finely.
• Too much coffee in the filter
basket.
• Coffee tamped too firmly.
• Water tank is empty.
• Water tank is not fully
inserted and locked into
position.
WHAT TO DO
Turn the STEAM/
HOT WATER dial to
the STANDBY position.
Machine will commence
heating.
Allow time for the machine
to reach operating
temperature. The POWER
button light will stop
flashing and all button lights
on the control panel will
illuminate when ready.
Fill tank.
Push water tank down
completely to lock into
place.
Refer to "Descaling",
page 26.
See below, "Espresso only
drips from the portafilter
spouts."
Use slightly coarser grind.
After tamping, trim the
coffee dose using the Razor™
dose trimming tool.
Tamp between 30-40lbs or
15-20kg of pressure.
Fill tank.
Push water tank down
completely to lock into
place.