Breville the Infuser Manuel D'instructions page 27

CARE & CLEANING
CLEANING THE STEAM WAND
• Immediately after texturing milk, turn
steam on to purge out any residual milk
from the steam wand then wipe the wand
with a damp cloth.
• If any of the holes in the tip of the steam
wand become blocked, ensure the STEAM/
HOT WATER dial is in the STANDBY
position. Press the POWER button to turn
the machine Off and allow to cool. Use the
pin on the end of the provided cleaning
tool to unblock the hole(s).
• If the steam wand remains blocked, remove
the tip using the integrated spanner in
the cleaning tool and soak in hot water.
Use the pin on the end of the provided
cleaning tool to unblock the hole(s) before
re-attaching to the steam wand.
CLEANING THE FILTER BASKETS
AND PORTAFILTER
• The filter baskets and portafilter
should be rinsed under hot water
immediately after use to remove all
residual coffee oils.
• If any of the holes in the filter basket
become blocked, use the pin on the
end of the provided cleaning tool to
unblock the hole(s).
• If the hole(s) remain blocked, dissolve
a cleaning tablet in hot water and
soak filter basket and portafilter in
solution for approx. 20 minutes.
Rinse thoroughly.
CLEANING THE SHOWER SCREEN
• The group head interior and shower
screen should be wiped with a damp
cloth to remove any ground coffee
particles.
• Periodically purge the machine. Place an
empty filter basket and portfilter into the
group head. Press and hold the 1 CUP
button and run a short flow of water to
rinse out any residual coffee.
CLEANING THE DRIP &
STORAGE TRAY
• The drip tray should be removed,
emptied and cleaned after each use
(after the auto purge feature, see page
17) or when the drip tray indicator is
showing Empty Me!
• Remove grill from the drip tray. Wash
both in warm soapy water. The Empty
Me! indicator can also be removed from
the drip tray.
• The storage tray can be removed and
cleaned with a soft, damp cloth (do not
use abrasive cleansers, pads or cloths
which can scratch the surface).
CLEANING THE OUTER HOUSING
& CUP WARMING TRAY
• The outer housing and cup warming tray
can be cleaned with a soft, damp cloth.
Polish with a soft, dry cloth. Do not use
abrasive cleansers, pads or cloths which
can scratch the surface.
NOTE
Do not use abrasive cleansers, pads or
cloths which can scratch the surface.
Do not clean any of the parts or
accessories in the dishwasher.
27