Service Guide - Dantherm CDF 35 Mode D'emploi

Service guide

Access to the
control
Remove the front panel by screwing off
two screws on top of the dehumidifier. Lift
the front panel vertically upwards and
then pull it horizontally away from the
unit
The control of the unit is located in a box on top of the compressor. To get access to
the control you have to unscrew the screws on the front of the box lid. Push the lid
backwards and then pull it away from the box.
Maintenance The dehumidifier requires very little attention for trouble free running. All the necessary
safety and control functions have been built in. The fan motor and the compressor have
permanent lubrication and require no particular maintenance.
Cleaning of the
dehumidifier
The air inlet filter has to be checked once
a month and cleaned, if necessary. Re-
move the front cover panel of the unit and
take out the filter for cleaning. It can ei-
ther be rinsed in tepid soapy water or, if
not very dirty, vacuumed with a vacuum
cleaner.
The drip tray and the drain must be
cleaned so that the water unhindered can
drain out
Once a year the front cover panel should
be removed in order to ...
... check the inside of the dehumidifier. If the dehumidifier is dirty it should be vacu-
19
CDF 35/45
CDF 35/45
um cleaned. The condenser in particular should be thoroughly vacuumed. If the la-
mella evaporator is badly soiled, it may be washed in tepid soapy water
CDF 35T/45T
Open the unit by removing the screws (4)
on the front of the unit, i.e. opposite to
the unit's duct openings. The screws may
be removed by means of the enclosed Al-
len key with hexagon head
CDF 35T/45T
The air inlet filter of the duct kit is to be
cleaned once a month. The filter is placed
in a stand behind the grill in the air inlet
duct. Remove the grill from the duct and
take out the filter. The filter is washed in
tepid soapy water or vacuum cleaned. Put
the filter back in the filter stand and fas-
ten the grill to the duct
Once a year the front should be removed
in order to ...