Philips AVENT SCD535 Mode D'emploi page 8

EngliSh
8
For ThE BaTTErY CoMparTMEnT, plEaSE Do noT opEn ThE
hoUSing oF ThE BaBY UniT anD parEnT UniT in orDEr To prEVEnT
ElECTriC ShoCK (Fig. 2).
To prEVEnT STrangUlaTion WiTh ThE poWEr CorD, alWaYS KEEp
-
ThE BaBY UniT anD ThE poWEr CorD oUT oF BaBY'S rEaCh, aT
lEaST 3.5 FEET/1 METEr aWaY. Do noT USE EXTEnSion CorDS.
Adapter for baby unit:
- Input: 100-240VAC 50-60Hz
- Output: 7.5 VDC 400 mA
- Adapter no. S004LU0750040
Adapter for charger:
- Input: 100-240 VAC 50/60Hz
- Output: 7.5VDC 500mA
- Adapter no. S004LU0750050
The socket-outlet shall be installed near the equipment and shall be easily accessible.
For the baby unit, only use 1.5V AA alkaline batteries (batteries not supplied).
For the parent unit, only use the SCD535 Li-Ion rechargeable battery pack as supplied with the
appliance.
Dispose of used batteries according to the instructions.
Compliance information
The term 'IC' before the certification number signifies that Industry Canada technical specifications
were met.This certification means that the equipment meets certain radio communications and
operational requirements. This device complies with Part 15 of the FCC Rules and RSS-213 of
Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
radio interference
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and ICES-003 of Industry Canada. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
rF radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 7 3/4
inches / 20 centimeters between the radiator and your body. For handheld operation, this
equipment has been tested and meets the FCC RF exposure guidelines. For body-worn operation,
this product has been tested and meets the FCC RF exposure guideline when used with the belt
clip or neck strap supplied with this product. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines. This equipment also complies with Industry Canada
RSS-102 with respect to Canada's Health Code 6 for Exposure of Humans to RF Fields.