Philips AVENT SCD535 Mode D'emploi page 16

EngliSh
16
Menu options
All functions can be operated on the parent unit, but some functions can also be operated on
the baby unit.
Menu operation - general explanation
Note: Menu functions can only be operated when a connection has been established between the baby
unit and the parent unit.
1 Press the MENU button to open the menu (Fig. 32).
The first menu option appears on the display.
,
2 Use the – and + buttons to select the desired menu option (Fig. 33).
Note: The arrow indicates in which direction you can navigate.
3 Press the OK button to confirm (Fig. 34).
4 Use the + and - buttons to select the desired setting.
5 Press the OK button to confirm.
The new setting flashes once. The message 'saved' also flashes once and then disappears from
,
the display.
6 Press the MENU button again to exit the menu.
ECo mode
Note: You can only switch the ECO mode on and off in the menu of the parent unit.
You can use the ECO mode to reduce the energy consumption of the appliance. Monitoring your
baby from a small distance requires less transmission power and less electrical power
than monitoring your baby from a large distance. When you monitor your baby from a small
distance, you can activate the ECO mode. In the ECO mode, the appliance consumes
less energy, but still ensures that you can always hear your baby clearly without any distracting noise.
Using the baby monitor in the ECO mode helps you to preserve the environment.
Note: The operating range of the baby monitor when it is operated in the ECO mode is 850 feet/260
meters in open air. Depending on the surroundings and other factor that may cause interference, this
range may be smaller.
1 Select 'ECO mode' with the + and - buttons (Fig. 33).
2 Press the OK button to confirm (Fig. 34).
3 If the ECO mode is off, the display shows 'On?'. Press the OK button to switch on the ECO
mode. If the ECO mode is on, the display shows 'Off?'. Press the OK button to switch off the
ECO mode.
If you have set the ECO mode to 'on', the parent unit switches off and on again. The ECO
,
mode symbol appears on the display of the baby unit and the parent unit to indicate that
both units now operate in ECO mode.
Note: The connection between parent and baby unit may be lost when the ECO mode is switched on. If
this happens, the operating range may be too large for the ECO mode. In this case, either reduce the
operating range or switch off the ECO mode.
nightlight on/off
1 Select 'Light' with the + and - buttons (Fig. 33).
2 Press the OK button to confirm.