Seal The Case; Check The Operation Of The Loaded Camera - Olympus PT-EP01 Mode D'emploi

Seal the Case

1 Close the Case gently while aligning the mounting projection of the rear lid and groove.
2 Turn the open/close dial counter clockwise.
• The Case is sealed.
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This will cause water leakage.
• Close the rear lid of the Case so that the lens cap or LCD hood strap doesn't catch. If it catches, water leaks
may result.

Check the operation of the loaded camera

After sealing the Case, check that the camera operations normally.
• Push the ON/OFF button on the Case and confirm that the camera turns ON/OFF.
• Turn the mode dial on the Case and confirm that the camera mode switches properly.
• Press the shutter lever on the Case and confirm that the camera shutter releases.
• Operate the zoom dial on the Case and confirm that the camera's lens is controlled.
• Operate other control button on the Case and confirm that the camera functions properly as intended.
En
EN 13
Close