afriso Eurovac HV Manuel D'utilisation page 82

A
A. Pump
B. Cable routed through upper
cable gland
C. Cable routed through bottom
cable gland
1. Connect the product directly to the supply mains without a switch and
without a plug.
The following applies if the product is operated in Switzerland: The power
supply line must be permanently installed and fused via the fuse of another,
continuously used consumer (e.g. a lighting system used on a daily basis).
This fuse must be designated "Leak detector".
2. If you want to route the mains cable or relay cable through the top of the
housing, replace the rubber grommet at the top of the housing by the
enclosed cable gland.
3. Close any cable glands of the product that are not used by means of the
enclosed plugs.
Mounting
B
D. Relay fuse
E. Relay connection
F. Mains connection
D
C
Eurovac HV
EN
E
F
25