Yamaha DSP-A595 Mode D'emploi page 20

ADJUSTING METHOD
Operations should be made while watching the information on this unit's display.
1
If you are using the remote control transmitter, set the
SELECTOR DIAL to the AMP/TUN or DSP position on the
remote control transmitter.
1
Turn the power on.
Front panel
2
Press SET MENU once or more to select the title
"1. CNTR" (so that "CNTR" appears on the display).
Front panel
* After pressing SET MENU once on the remote control
transmitter, you can also select the title by pressing .
(Pressing goes back one selection.)
20
2 3
or
Remote control
or
Remote control
or
Appears.
1
3
Press + or – once or more to select the position you
want.
Front panel
4
Repeat steps 2 and 3 to change selections on
"2. REAR", "3. MAIN", "4. BASS" and/or "5. M.LVL" in
the same way.
3
2
Remote control
or
Changes.