Menu Settings - Renkforce AN-8006 Notice D'emploi

Menu settings

Volume control / dial control (2)
In standard operation, the volume control / dial control (2) is for setting the volume.
Press the control once or several times, to change the parameters BAS (bass control), TRE (treble control), BAL
(balance control) and FAD (fader control) by turning the control.
To select further functions, first press the volume control/selection button (2) a little bit longer (>2 seconds) and then
press this button once more, but only very shortly, until the desired function appears on the display:
You select the options for the respective setting by twisting the volume control/selection button (2) or by pushing the
volume buttons (2) on the remote control.
Activation volume INVOL
The preset volume is selected when turning the device on.
Set the desired activation volume by turning the volume control/selection control (2).
Setting the time ADJ
• Turn the volume control/dial control (2) clockwise to set the hours.
• Turn the volume control/dial control (2) counter-clockwise to set the minutes.
• This setting is applied automatically when the display returns to the basic setting.

When receiving an RDS station with time transmission, the clock adjusts automatically to the correct
time and the manually set time is overwritten with the RDS time.
Button acknowledgement signal BEEP
You can set the button acknowledgement beep in three different ways:
BEEP ALL: The signal sounds at every push of a button.
BEEP 2ND: The beep only sounds if a button is pressed longer to select the second button function.
BEEP OFF: The signal is off.
63