Removal - Renkforce AN-8006 Notice D'emploi

• Protect your CD tuner against vibrations with the bolt at the back of the unit. In most vehicles, such a safety
fastening is provided for. If this is not the case in your car, fasten the CD tuner with the enclosed punched metal
strip. For the fastening, proceed as follows.
• When you have made all the electrical contacts (see "Electric Connection") insert the CD tuner into the frame until
it locks in.
• Replace the frame cover of the front control panel.

Keep the two unlocking keys. You will need them for a later removal of the CD tuner.

Removal

• Remove the front control panel.
• Carefully remove the plastic frame in the front of the system, by bending it slightly to the outside and pulling it off
from the unit.
• Insert the two unlocking keys into the lateral slots between the CD tuner and the installation frame, until the CD
tuner unlocks.
• Remove the fastening screw at the back of the unit.
• Carefully pull out the radio with the unlocking keys from the installation frame.
• Disconnect all connectors from the device
54
Operating instructions

English