Nilox E-BIKE DOC X5 Mode D'emploi page 8

BATTERY ASSEMBLY
Insert the battery in its housing as shown in the figure.
The fitted battery will look as shown in the figure.
BRAKE ADJUSTMENT
The brake levers are made of aluminium alloy.
Next to the brake lever is a gauge to adjust the tension of the wiring.
During braking, the electrical part of the motor is automatically disabled.
The brakes are classic V brakes.
BRAKE CALIBRATION
the brake pad and the rim must be no more than 2-3 mm. (B+C)
EN
Gently push upwards so the battery fit into its housing.
Use an Allen
wrench to adjust
the angle of the
braking unit and
a cross-tip
screwdriver to
adjust the
distance of the
brake pads from
the rim.
Brake pads must be kept parallel to rims, and the distance between
6