Télécharger Imprimer la page

Nilox E-BIKE DOC X5 Mode D'emploi page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
Regularly check the tyre pressure.
Check that the handlebar and saddle are always well secured.
Adjust the chain tension and lubricate it periodically.
Before each use always check the reliability of the braking system.
Check that the wheel bolts are tightened.
Check the condition of the tyres and replace them when worn.
Do not wash DOC E-BIKE X5 directly with jets of water, especially pressurised, since this could
damage the electrical components.
Clean dirty areas with a damp cloth and neutral detergent; then dry with care.
Treat the metal moving parts such as the chain with lubricating oil. TAKING CARE THAT NO
OIL DRIPS ONTO THE BRAKING PARTS. We recommend you have these operations performed
by qualified personnel.
Regularly check the tension of the chain, by releasing the quick-coupling clamp and holding
the wheel. Make sure that the wheel is perfectly in axis.
Frequently check the reliability of the brakes.
CORRECT USE AND MAINTENANCE OF THE BATTERY
The following covers different methods of recharging and maintaining the battery, as well as any problems
that may arise. For the safety of the consumer and to prolong the life and improve performance of the
battery, please observe the following:
The battery and the battery charger must be kept out of children's reach.
Use the maximum speed of the PAS only with the battery fully charged.
Only use the original battery charger; the use of a different battery charger could damage it
irreparably.
Do not disassemble or modify the battery and/or its charger.
Be extra careful when removing the battery from the DOC E-BIKE X3, dropping it could damage
it and make it unusable.
In the presence of unpleasant smells or excess temperatures during charging, stop the
procedure immediately.
DOC E-BIKE X5 cannot be used during the battery charging process.
The battery and the battery charger must be kept out of children's reach.
Make sure the battery and charger are connected before connecting to the electricity mains.
Never let the battery charge level fall to zero, as this could reduce its life.
Do not submit the battery to excessive charge cycles, if not needed.
If the bike is not used, recharge the battery at least every 2 months.
Do not charge the battery at high temperatures (above 40 C)
In winter, battery charging should be carried out at room temperature, if the bike was left in the cold
start the charging process after it has been brought back to room temperature.
Batteries contain hazardous substances. Do not open the battery and do not insert anything inside
it.
If over-charged, lithium batteries may explode.
Please keep the charging contacts clean and dry.
If the charging port is wet, do not charge.
In order to avoid fire risks or electrical shock, when charging, only place the device in a room with
controlled temperature and humidity and without conductive agents of any kind.
When charging, the device should be placed in a fully fireproof room (keep away from wood floors,
furniture, paper, sofas, rugs, flammable liquids, etc. .) with controlled temperature and humidity.
Charge the battery in a ventilated room to reduce overheating when charging.
If the battery suffered shocks or if the battery or power cord are not perfectly intact, avoid charging
and contact a service centre.
The manufacturer and distributor cannot be held liable for damages to third party products due to
EN
9

Publicité

loading