CIAT MAJOR LINE 102A Manuel D'instructions page 34

NCV, NCH Model without Casing (fig. 2)
1 - Heat exchange coil
2 - Fan motor assembly
3 - Access to motor terminal
4 - Main ABS PC single unit condensate
drain pan with insulation reinforced
by PSE panelling
5 - Condensate drain Ø 22mm
6 - Ancillary condensate drain pan
7 - Slots for attaching to the wall or
ceiling
Name plate (fig. 3)
The name plate contains all the information required to identify the unit and its
configuration. This plate is placed on the condensate pan insulation. Before
contacting us, please note the serial no. and the designation.
1 Code
2 Serial number
3 Unit designation
4 Rated motor output
5 Motor rotation speed
6 Type of coil
IMPORTANT:
This unit may be used by children aged eight and over, and by persons with limited
physical, sensory or mental capabilities, or by persons with insufficient experience or
knowledge, provided that they are being correctly supervised or provided they have
received instructions on how to use the unit in complete safety, ensuring that they
have a full understanding of any risks involved. Children must not be allowed to play
with the unit. User cleaning and maintenance must not be performed by children.
During normal use, this unit is intended to operate under the following site conditions:
- Maximum altitude: 2000 m,
- Minimum and maximum storage temperature: -20°C +65°C,
- Minimum and maximum operating temperature: 0°C +40°C,
- Indoor return air maximum humidity level: 27°C DB (dry bulb) at 65% RH (Relative
Humidity),
- Clean interior environment (no corrosive substances present).
The unit requires protection from any form of impact during use. Protection rating IP
20 IK02.
This unit is designed to operate in an overvoltage category II and pollution degree 2
environment, in accordance with IEC standard 664. To ensure a pollution degree 2
environment, the unit must be protected from water and oil splashes, and the dust
allowed to settle on it must be limited.
8 - Valve(s) (option or accessory)
9 - Air bleed screw
10 - Coil drain screw
11 - Air filter
12 - Resilient mount (accessory)
13 - Supply and return plenums, H or U
assembly (option)
14 - Supply plenums (accessory)
7 Wiring diagram reference
8 Motor speed wiring
9 Maximum service pressure
10 Specifications for electric heater
if present
11 CE declaration no.
EN - 2