Prepare The Collar Receiver - SportDOG SD-105C Mode D'emploi

Système de dressage de courte distance
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STEP :: 02

PREPARE THE COLLAR RECEIVER

INSERTING 3-VOLT BATTERIES
1. Use a small Phillips screwdriver to remove the two screws on the Collar Receiver.
2. Press the battery door up in the direction of the arrows on the door. It will move up slightly and the
door will release.
3. Insert two (CR2032) 3-volt lithium batteries (positive side up) per the markings found on the
battery door gasket.
4. Replace the battery door. To ensure waterproofness, check that the gasket is in place and clean.
5. Tighten the screws. Do not over tighten.
PRESS DOOR UP
TO TURN THE COLLAR RECEIVER ON
1. Press and hold the On/Off Button until the Receiver Indicator Light
comes on and the Collar Receiver beeps 5 times.
2. Release the On/Off Button.
The Receiver Indicator Light will flash until the Collar Receiver is
turned off. The flashing light indicates the Collar Receiver is ready to
receive a radio signal from the Remote Transmitter.
TO TURN THE COLLAR RECEIVER OFF
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and the Collar
Receiver beeps 2 times.
2. Release the On/Off Button.
NOTE: Maximum battery life is one month. If the Collar Receiver is left on continuously, the
maximum battery life will be 1-2 weeks. To extend the battery life, turn the Collar Receiver off when
it is not in use.
RECEIVER INDICATOR LIGHT
COLLAR RECEIVER FUNCTION
Collar Receiver on - good battery
Continuous static stimulation button pressed
Tone stimulation button pressed
8
PULL DOOR OUT
INDICATOR LIGHT RESPONSE
Flashes once per second
Solid in colour
No response
1-800-732-0144
GASKET
ON/OFF
BUTTON

Publicité

Chapitres

Table des Matières
loading

Table des Matières