Match The Remote Beeper - SportDOG SPORTTRAINER ADD-A-BEEPER Mode D'emploi

match the remote Beeper

To match the Remote Beeper to work with a new Remote Transmitter or to program a new
Remote Beeper to work with your existing Remote Transmitter (SD-1875, SD-1875E,
SD-1825, SD-1825CAMO, SD-1825E):
A. Check to make sure the Remote Beeper is off.
B. Press and hold the On/Off Button. The Remote Beeper Indicator Light will come on, then
turn off after 4-5 seconds. If the On/Off Button is released too early, the Remote Beeper
Indicator Light will begin flashing as normal. If this occurs, start over from a.
C. After the Remote Beeper Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Remote Beeper
Indicator Light flashes 5 times. Once the Remote Beeper Indicator Light has flashed 5
times, the Remote Beeper has been matched and will begin flashing as normal. If the
Remote Beeper Indicator Light does not flash 5 times, start over from a.
Note: For more information on programming modes, please consult the original Operating Guide
that came with your SD-1875, SD-1875E, SD-1825, SD-1825CAMO, or SD-1825E system. Visit
our website at www.sportdog.com to download any of these Operating Guides.
WWW.SPORTDOG.COM
5