Operate The Bark Control Collar; Turning The Unit On/Off - SportDOG SBC-R Manuel D'utilisation

STEP :: 02

OPERATE THE BARK CONTROL COLLAR

TURNING THE UNIT ON/OFF

Press and release the power button (located between the contact points). The unit will power on
immediately, as well as tone. To turn the unit off, press and hold the power button for 3 seconds.
A tone will sound, then the unit will turn off.
NOTE: If the user dose not press any button, the display will go blank after 15 seconds. To wake
up the display, press and release the power button.
CHANGING THE MODES
The SBC-R-E has 3 modes of operation. These 3 modes are indicated by icons shown on the OLED
display. The following table summarises the 3 modes and their corresponding icons:
TEMPERAMENT LEARNING
When the display is active (on) press and release
the power button. The mode icon will flash,
indicating that you can change modes. Press the
+/- buttons until the desired mode is selected.
After changing modes, pressing and releasing
the power button again while the mode is
blinking will allow you to change the static
stimulation levels if you are in User-Selected
or Temperament Learning modes. Pressing the
+/- buttons will cycle through the static stimulation levels. Temperament Learning static
stimulation levels can only be reset to 1 by pressing the - button, or reset to the last "learned"
level by pressing the + button.
Plus and minus buttons have no function when displaying Progressive Stimulation mode as it
always starts at 1.
NOTE: In User-Selected mode, always start training at the lowest level of static stimulation.
Watch how your dog reacts, and if necessary, increase to the next static stimulation level.
8
PROGRESSIVE STIMULATION
+/- BUTTONS
SPORTDOG.COM
USER-SELECTED
POWER BUTTON
MODE DISPLAY