babymoov A040006 Notice D'utilisation page 9

a. Push bar
b. Plate
c. Push bar attachments
d. Seat
1. Assembly of the plate (b)
Insert the push bar (a) in the push bar attachments (c). Clip the assembly in the plate (b).
2. Assembly of the cover (e)
Insert the cover (e) in the seat structure (d) passing the strips through the slots designed for them.
CAUTION: make sure that the cover (e) is correctly installed.
3. Installation of the seat (d)
Position the front of the seat (d) on the plate (b). Press on the back of the seat (d) in order to engage it completely.
4. Assembly of the wheels (g) and the brakes (h)
Assemble the wheels (g) and the brakes (h). Make sure that each item is well engaged.
5. Installation of the play panel (f)
Unscrew the case located under the play panel (f) and insert two LR6 1.5V (AA) batteries (not included).
Close the case and screw it into place.
Position the play panel (f) on the plate (b). Pull the tongue located under the plate (b) and turn it to lock
the play panel (f).
Install the toys in the places designed for them on the play panel (f).
6. Unfolding/folding of the baby walker
To unfold the baby walker, raise it till it locks into place.
To fold the baby walker, turn the button located under the plat (b) in the clockwise direction and push
upwards. Hold the plate (b) with the other hand and fold it down completely.
7. Height adjustment (3 positions)
To adjust the height of the seat, turn the button located under the plate (b) in the clockwise direction. Hold
the plate (b) with the other hand and adjust it to the required height.
CAUTION: never put your child in the baby walker before it is correctly locked at the required height.
8. Pusher function
Remove the seat (d) by unlocking it at the back. Unlock the push bar (a) from its attachments (c). Position
it in the reverse direction and insert it once more in the push bar attachments (c). The product can now
be used for learning to walk.
CAUTION: Make sure that the bar (a) is correctly installed before putting your child in the 2 in 1 baby
walker set to the pusher function.
- The materials are in compliance with the standards for toys and fabrics with azoic colouring. Nevertheless
we advise you not to expose the model too long to direct sunlight. Wear and faded or running colours due
to exposure to direct sunlight do not justify any claim. Covers can be washed by hand or in the machine at
low temperature (washing product for delicate clothes).
- All the parts of the baby walker can be cleaned with mild soap using a wet cloth. Dry the metal parts to
prevent them from rusting.
- If you observe the above advice, you can make the most of your 2 in 1 baby walker for a long time.
COMPOSITION
INSTRUCTIONS FOR USE
SERVICING
2 IN 1 BABY WALKER • Instructions for use
e. Cover
f. Play panel
g. Swivelling wheels
h. Brakes
9