SSS Siedle SET CV 850-01 Information Produit page 28

Programming - manual
Programming internal calls
Application
You wish a bus telephone to be
able to call and communicate
with another bus telephone in the
system.
An internal call for the BVPC 850-...
is programmed at the PC using
1 Switch on the programming mode.
At the VSNG 850-..., press the pro-
gramming mode button briefly. The
LED1 flashes in a 2-second rhythm
to indicate that the programming
mode is active.
4 Lift the receiver at the second
bus telephone you wish to enable
for internal calls. The programming
mode tone is audible.
22
the bus programming software
BPS 650-...
The muting and light buttons of
the bus telephones can be repro-
grammed if required for internal call
functions.
2 Lift the receiver at the first bus
telephone you wish to enable for
internal calls. The programming
mode tone is audible.
5 Hold the light button down for
4 seconds. The acknowledgement
tone is audible. Do not replace the
receiver.
3 Hold the light button down for
4 seconds. The acknowledgement
tone is audible. Do not replace the
receiver.
6 A speech connection now exists
between the two bus telephones.