Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Press the
button on the rotating laser and the PRA 30G laser receiver.
▶ The laser switches on, the beam begins to rotate and the "auto leveling" LED lights as soon as the
tool has leveled itself.
4. Press the
button on the rotating laser.
▶ The inclined plane mode LED on the rotating laser lights constantly.
▶ The inclined plane mode symbol is shown on the PRA 30G laser receiver.
5. Use the
or
buttons on the laser receiver to incline the laser plane.
When the angle of inclination is set manually, the rotating laser levels the laser plane once and
then fixes it once. Note that this rotating laser does not correct the sloped laser plane for possible
deviation occurring due to a change in ambient conditions and/or shift of the mounting. Vibration,
changes in temperature or other influences that may occur during the course of the day may affect
the position of the laser plane.
5.11
Setting the inclination using the PRA 79 slope adapter
Depending on the application, the PRA 79 slope adapter can be mounted on a tripod or on a wall
bracket.
The angle of inclination of the PRA 79 slope adapter is set to 0°.
1. Mount the rotating laser on the PRA 79 slope adapter. Observe the operating instructions for the PRA 79
slope adapter. The control panel of the rotating laser should be facing you.
2. Position the rotating laser either at the upper edge or lower edge of the inclined plane.
3. Press the
button on the rotating laser.
▶ The laser switches on, the beam begins to rotate and the "auto leveling" LED lights as soon as the
tool has leveled itself.
4. Press the
button on the rotating laser.
▶ The inclined plane mode LED on the rotating laser lights constantly.
5. Set the PRA 79 slope adapter to the desired angle of inclination.
When the angle of inclination is set manually, the rotating laser levels the laser plane once and
then fixes it once. Note that this rotating laser does not correct the sloped laser plane for possible
deviation occurring due to a change in ambient conditions and/or shift of the mounting. Vibration,
changes in temperature or other influences that may occur during the course of the day may affect
the position of the laser plane.
5.12
Setting inclination automatically
The rotating laser, depending on the application, is mounted or positioned securely.
The PRA 30G laser receiver and the rotating laser are paired.
The PRA 30G laser receiver and the receiving side of the rotating laser are facing each other and in
direct line of sight. The best receiving side of the rotating laser is the side at which the battery is inserted.
1. Position the rotating laser either at the upper edge or lower edge of the inclined plane.
2. Press the
button on the rotating laser and the PRA 30G laser receiver.
▶ The laser switches on, the beam begins to rotate and the "auto leveling" LED lights as soon as the
tool has leveled itself.
3. Press the
button on the rotating laser.
▶ The inclined plane mode LED on the rotating laser lights constantly.
▶ The inclined plane mode symbol is shown on the PRA 30G laser receiver.
4. Position the marking notch on the PRA 30G laser receiver at the other edge of the inclined plane.
5. Begin automatic alignment by double-clicking the
corresponding function in the AUTO menu.
▶ The rotating laser inclines the laser plane on the X-axis automatically until the mark at the PRA 30G
laser receiver is reached. An signal tone is emitted by the laser receiver repeatedly during this
procedure.
12
English
13
button on the PRA 30G laser receiver or select the
2179604
*2179604*
Publicité
Table des Matières
