Led Indicators - Hilti PR 30-HVSG A12 Mode D'emploi Original

3.10 Switching off beam segments
Individual segments of the path of the laser beam can be deactivated in order to:
• Avoid exposing yourself or bystanders to the laser beam.
• Avoid influencing other measuring or alignment work being carried out in the vicinity.
3.11 Laser receiver / remote control unit
Hilti laser receivers digitally indicate the distance between the marking notch on the laser receiver and the
position at which the laser beam (laser plane) strikes the detection area on the receiver. The laser beam can
also be received over long distances. The PRA 30G can be used as a laser receiver and also as a remote
control unit for the rotating laser.
3.12 Pairing accessories and device
Pairing accessories and device
Pairing is the act of enabling accessories and devices to communicate with each other by wireless.
The rotating laser and the laser receiver are already paired when supplied. This helps ensure trouble-free
operation within the vicinity of other wireless devices.
Additional laser receivers or PRA 90 automatic tripods cannot be used without first being paired.
3.13

LED indicators

The rotating laser is equipped with LED indicators.
Status
All LEDs blink.
The auto-leveling LED flashes green.
The auto-leveling LED shows steady green.
The shock warning LED shows steady orange.
The inclination LED shows steady orange
The surveillance LED flashes orange.
The surveillance mode LED shows steady orange.
3.14 Li-ion battery charge state display
The Li-ion battery features a state of charge display.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
When the tool is in operation, the battery charge status is indicated in the display on the tool.
When not in operation, battery charge state can be indicated by lightly pressing the release button.
During charging, charge state is indicated by the LEDs on the battery (please refer to the operating
instructions for the charger).
3.15 Items supplied
PR 30-HVSG A12 rotating laser, PRA 30G laser receiver / remote control unit, 2 batteries (AA cells), PRA 54
target plate, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group.
*2179604*
Meaning
The tool has been bumped, knocked off level or
has a fault.
The tool is in the leveling phase.
The tool has leveled itself / is operating normally.
Shock warning mode is deactivated.
Inclined plane mode is active.
The tool is aligning the laser plane with the
(PRA 30G) reference point.
The tool is in surveillance mode. Alignment with the
reference point (PRA 30G) is correct.
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
2179604 English 7