Instructions On Use And Set-Up Of The Eos Relax; Noise Generation/Creaking; Indoor Climate - philrouge EOS RELAX Mode D'emploi

6.
Instructions on use and set-up of the EOS
Relax
6.1.

Noise generation/creaking

Our bed systems are designed and constructed to prevent noise or keep it to a
minimum, so that it does not become a nuisance.
However, an essential condition for the above is that the steps in the assembly
instructions are followed when assembling and installing the bed.
It is also necessary to ensure that the bed is set up in a manner that avoids dis-
tortion and stresses. Uneven installation on carpet edges and sloping floors will
result in distortion.
6.2.

Indoor climate

Protect your bed from direct sunlight or very bright light, as no wood or fabric is
completely fade-proof. High-energy neon or halogen light can also cause colour
and material changes as well as bleaching.
Ideally, the humidity level in the room should be between 45% and 55%. At
lower values, natural materials become brittle and synthetic fibres have a higher
tendency become electrostatically charged and/or soiled. Higher humidity le-
vels promote mould formation.
- Ventilate your bedroom regularly (short periods of full ventilation).
- Ensure sufficient air circulation on and under the mattress. We recommend
shaking pillows and duvets regularly and, ideally, leaving the latter pulled
back for a few hours
aired.
- In particular, if an additional mattress topper is used, this must be turned
from time to time.
don't replace the covers until the bed has been well
88