Photonic HPRL Mode D'emploi page 15

Settings
You can enter the setup menu by pressing both encoders (1 + 2) approx. 4 seconds long.
There are 4 setting points for which one LED (S1-S4) is available for each. By turning the encoder (1),
you can control the desired setting point. Pressing the same encoder (1) changes the value of this
setting. The set value is indicated by the flashing or lighting of the respective LED.
Setup LED constantly lit (default)
S1 Safety
connecting to the power supply. After
power on the last lighting scenario
follows
S2 Logarithmic brightness control
S3 Brightness encoder right and segment
selection left
S4 Brightness control by analogue current
setting
The default settings are defined in the first column ("LED constantly lit")
By prolonged pressing of both encoders (1 + 2) the settings are saved and the setup menu is exited.
Factory reset
To do so, pull the power supply (6) and then press and hold the on/off switch (3) while you plug the
power supply back in. Press and hold the on/off switch until the LEDs flash briefly several times.
mode: Light OFF
15 | 28
LED flashes
after Connector strip mode: Light ON after
connecting to the power supply. Automatic
start with the saved lighting scenario
Linear brightness control from 1-100%
Brightness encoder
selection right
Brightness control over the duty factor of a
PWM signal
left and segment